Winboard Forum

Hi all

Hould like to reduce the pieces in the board of WB.
It is not possible?

Best
Rogerio

Rogerio Ribeiro wrote:Hi all

Hould like to reduce the pieces in the board of WB.
It is not possible?

Best
Rogerio

I don't understand what you want to do exactly. Would you like to change the size? That should happen automatically. Or would you like to edit the position? Try "Mode", "Edit Position" and then right click in the board.

Volker

Hi

Only to reduce the pieces and no board.

Best
Rogerio

Rogerio Ribeiro wrote:Hi

Only to reduce the pieces and no board.

Best
Rogerio

Then "Mode", "Edit Position" and then right clicking in the board should do what you like.

Volker

Volker Pittlik wrote:

Rogerio Ribeiro wrote:Hi

Only to reduce the pieces and no board.

Best
Rogerio

Then "Mode", "Edit Position" and then right clicking in the board should do what you like.

Volker

I think he means reducing the size of the pieces relative to the size of the squares, but I'm afraid this is not possible.

G?bor

G?bor Szots wrote:

Volker Pittlik wrote:

Rogerio Ribeiro wrote:Hi

Only to reduce the pieces and no board.

Best
Rogerio

Then "Mode", "Edit Position" and then right clicking in the board should do what you like.

Volker

I think he means reducing the size of the pieces relative to the size of the squares, but I'm afraid this is not possible.

G?bor

Hi

Thank you to all for the attention.
My doubt was explained by G?bor.

Best
Rogerio