Greetings,
I'm running WinBoard and invoking a UCI engine via Polyglot. (In this case, Houdini 1.5)
In my polyglot ini file for that engine I'm using the Gaviota tablebases:
GaviotaTbPath = D:\Chess\Tablebases\Gaviota\gtb.cp4
GaviotaTbCache = 16
GaviotaUsage = Rarely
After WinBoard is loaded, I setup an endgame test position, with just five pieces.
When I chose MODE - TWO MACHINES, both machines instantly carry out their respective best moves. Upon checking that initial position that I set up, I confirm the endgame table bases are working. So far so good.
However, after setting up the position, if instead I chose MODE - ANALYSIS MODE, I briefly, for a quick second, see output in the analysis engine pane window. (I think that's what that window is called.) And then, that output disappears completely and doesn't return.
If I make a move on the board, the same thing happens - for a very brief quick second, barely enough time to read it, I see output appear in the window pane and then disappear.
What I'm hoping to see, of course, is a mate announcement of some kind. (That stays there, naturally.)
Upon checking the logfile that is produced, I can see that the # of moves to mate is listed in the file. This also confirms that polyglot/the engine are using the tablebases and that they are working as they should. But shouldn't that mate announcement be shown in the pane?
As always thanks in advance (H.G.) for any replies.
Ed